Hinge; Black 1-1/8" Pan Head Screw - Sauder Harbor View Serie Instructions D'assemblage

Step 9
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the LEFT DOOR (I) to the LEFT END (B). Use the
å
screws in the HINGES. See the next step for adjustments.
Fasten a KNOB (105K) to the LEFT DOOR (I). Use a
å
BLACK 1-1/8" PAN HEAD SCREW (9S).
Peel the FELT DISC from the FELT DISC CARD (1M). Stick
å
a FELT DISC on the DOOR where it comes in contact with
the SHELF (E).
Repeat this step for the RIGHT DOOR (H).
å

BLACK 1-1/8" PAN HEAD SCREW

(2 used in this step)
www.sauder.com/services
9S
1M
105K

Hinge

I
B
416825
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
E
Page 13