Bosch CTL7 Serie Manuel D'utilisation page 46

en Preventing
2 Preventing material
Pr e v e nt i n g
damage
Pr e v e nt i n g
ATTENTION!
Risk of damage to the appliance. If
the appliance is not started up cor-
rectly, it may be damaged.
▶
Use the appliance in frost-free
rooms only.
▶
If the appliance has been transpor-
ted or stored below 0 °C, wait
3 hours at room temperature be-
fore starting it up.
▶
After plugging in, always wait ap-
prox. 5 seconds.
Improper installation may cause ma-
terial damage.
▶
Observe the installation instruc-
tions for the appliance installed
above or below.
▶
When installing the appliance
above a warming drawer, observe
a niche height of 590 mm.
Unsecured units may fall over.
▶
Secure units to the wall using a
standard bracket.
3 Environmental protec-
tion and saving energy
3.1 Disposing of packaging
The packaging materials are environ-
mentally compatible and can be re-
cycled.
▶ Sort the individual components by
type and dispose of them separ-
ately.
3.2 Tips for saving energy
If you follow these instructions, your
appliance will use less power.
46
Set the interval for automatic switch-
off to the smallest value.
a If the appliance is not being used,
it will switch itself off earlier.
→ "Basic settings", Page 57
Do not interrupt the dispensing pro-
cess prematurely.
a The amount of water or milk that is
heated is used optimally.
Descale the appliance regularly.
a Limescale deposits increase the
appliance's energy consumption.
4 Installation and con-
nection
4.1 Scope of delivery
After unpacking all parts, check for
any damage in transit and complete-
ness of the delivery.
Note: Different accessories are en-
closed depending on the appliance
model. This accessory is shown in a
frame with a dashed line.
→ Fig. 1
A
Fully automatic coffee ma-
chine
B
Milk container
C
Milk tube and suction pipe
D
Installation instructions
E
Cleaning tablet
F
Descaling tablet
G
Water filter
1
Depending on the appliance spe-
cifications
1
1
1