ALEAPOW P10 Manuel D'instructions page 9

Charging a Battery
NOTE: To ensure maximum performance and life of lithium-ion battery packs, charge the battery pack
fully before first use.
1. Plug the charger into an appropriate outlet before
inserting battery pack.
2. Connect the charger and battery pack, making sure the
battery is fully seated. The (charging) light will blink
continuously indicating that the charging process has
started.
3. The completion of charge will be indicated by the light
remaining ON continuously. The battery pack is fully
charged and may be removed and used at this time or
left in the charger.
Indicator for Charging Process
Refer to the information below for the charge status of the battery pack.
The Red LED always light when the battery is charging.
The Green LED always light if the battery is fully charged
The Battery will not be charged if the battery temperature is deviation. In that case, the Green
LED flashes until the battery cool down to normal temperature.
The battery will never be charged if the battery is damaged. In that case, the red LED always
flashes.
1. Installing and Removing the Battery Pack (FIG. 3)
NOTE: For best results, make sure your battery pack is fully charged.
● To install the battery pack (10) into the tool handle, align the battery pack with the rails inside the
tool's handle and slide it into the handle until the battery pack is firmly seated in the tool and ensure
that it does not disengage.
● To remove the battery pack from the tool, press the release button (11) and firmly pull the battery
pack out of the tool handle. Insert it into the charger as described in the charger section of this
manual.
Assembly/Adjustment setup
- 07 -
11
12
13