ALEAPOW P10 Manuel D'instructions page 12

Always hold the polishing machine close to the surface. This way, the machine will work more
efficiently also prevent the polishing liquid from splatter.
1. Attach the polishing pad to the backing pad, make sure it is centred well
2. Put amount of wax / polishing liquid on the polishing pad
3. While keeping the machine switched off, devide the product over the surface to be polished. This
will limit splatter and make sure the product is evenly devided over the surface. When working
large surfaces, split it into smaller parts and treat them one by one.
4. Put the machine on to the surface, then switch it on at the lowest speed. Continue to spread the
product over the surface to be polished. Hold the machine firmly and make sure you have a good
foothold.
5. Raise the speed and apply the product in straight tracks. Make sure there is a 50% overlap in these
tracks. Move slowly over the surface until the polishing product has become transparent or has
dried (depending on the type of product you are using).
6. Clean any remaining product with a microfiber cloth (manually) or a lambs wool polishing pad that
fits with the machine.
WARNING: Blow dirt and dust out of the main housing with dry air as often as dirt is seen collect-
ing in and around the air vents. Wear approved eye protection and approved dust mask when
performing this procedure.
WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid get inside the tool; never immerse any part of
the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC outlet before cleaning. Dirt and
grease may be removed from the exterior of the charger using a cloth or soft non-metallic brush.
Do not use water or any cleaning solutions.
Storage Recommendations
1. The best storage place is one that is cool and dry away from direct sunlight and excess heat or
cold. For optimum battery performance and life, store battery packs at room temperature when not
in use.
2. For long storage, it is recommended to store a fully charged battery pack in a cool, dry place out of
the charger for optimal results.
NOTE: Battery packs should not be stored completely depleted of charge. The battery pack will need
to be recharged before use.
LpA (sound pressure) 76.0 dB(A), Uncertainty (K) 3 dB(A)
LWA (sound power) 87.0 dB(A), Uncertainty (K) 3 dB(A)
Vibration total values (triax vector sum) according to EN 62841:
Cutting Wood (ah, W) 1.5 m/s2, uncertainty (K) 1.5 m/s2
Cleaning
- 10 -