Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation
This machine can be used for manually polishing or waxing, with a higher speed and higher intensity
than a rotary machine. The machine makes excentric movements also called Dual Action. This means
it makes many small oval movements per minute that are comparable to rotating hand movements.
The rotations are ovals which never follow 100% the same track because the polishing pad rotates
feely around the axle. Because the machine has this excentric movement, the chance of holograms,
machine tracks, burn marks and other damage to laquer is much smaller. This contrary to normal
rotating polishing machines or rotary machines.
Handles
This machine is supplied with two handles. The side handle can simply be screwed unto the machine.
The other handle can be used in several ways (see the images below). To change the position of the
handle loosen the screws with the supplied hex key tool. The handle can then be moved to the
desired position.
Position1
Installing the polishing pad (figure 1)
1.
Place the tool on a flat surface with the backing pad (A) pointed upwards
2.
Remove any dust that might be on the backing pad
3.
Place the polishing pad unto the backing pad and press firmly
4.
Test the machine on a flat service and start the engine. Always make sure to test the machine and
make sure the polishing pad is properly fixed before using the machine on a lacquered surface.
5.
Remove the polishing pad by pulling it from the packing pad.
Position2
- 08 -
Position3
Publicité
Table des Matières
