Plamen Alberto Directives Techniques page 24

The recommended quantities for fuel which is to be added only once:
Chopped wood ( approx. 33 cm long)
Large fuel quantities can leave the glass door partially dirty.
FIRING
WARNING! Do not use alcohol and petrol or for ignition or re-ignition.
Since the stove is made in gray cast, it is necessary to take into account that this particular
material can feature cracks and fractures due to sudden and uneven thermal load. That is why it
is advisable to apply moderate fire at first few firings.
At first firing the appearance of unpleasant smell (due to drying glue on sealing's and
protective coat) is inevitabale, but this will vanish after a few uses. In any case, the space should
be thoroughly aired.
At first firing we advise you to use a smaller quantity of fuel and to slowly increase it. At firing,
please pay attention to the following advice:
1 make sure the room in which the stove is located is thoroughly aired
2 at first firings do not overload the firebox (use about a half of the recommended quantity)
3 repeat the procedure 4 to 5 times
4 add more fuel (observing the maximum fuel quantity limitations) and keep the appliance
operating for as long as possible, i.e. avoid short periods of firing and extinguishing, at
least in the beginning
5 the stove surface is to be kept free from any objects at first firings. Painted surfaces are not
to be touched during heating.
We advise the use of chopped wood, paper and other firing agents for kindling. Use of
liquids, such as spirit, petrol, oil, etc., is strictly forbidden.
When starting the fire, leave the firebox door slightly open (for 4-5 min) in order to avoid
moist from condensing on the glass. Do not leave the stove unobserved until the fire is fully
burning in order to control the fire. When the fire is burning well, open the regulator on the
door and close the door.
Under normal functioning the door is to be kept closed, except when wood is added.
If your flue pipe features a flap valve, keep it fully open until the fire is fully burning.
The stove is constructed in such a way to allow the glass to be kept clean at all times. The
glass can get soothed if combustion is poor. Possible reasons for poor combustion are the
following:
1 poor chimney quality
2 damped airflow
3 unsuitable fuel
4 the firebox is overloaded
WARNING! The stove will get hot and can be operated only by adults.
USE THE PROTECTIVE GLOVE.
2 to 3 pieces
24
approx. 3 kg/h