Dell Latitude D500 Guide D'informations page 26

Turn on the computer. When the DELL™ logo appears, press
4
NOTE: If you see a message stating that no diagnostics utility partition has been found, run the
Dell Diagnostics from your Drivers and Utilities CD.
If you wait too long and the Microsoft
until you see the Windows desktop. Then shut down your computer and try again.
When the boot device list appears, highlight Diagnostics and press
5
The computer begins to run the Pre-boot System Assessment, a series of embedded
diagnostics that perform initial testing on your system board, keyboard, hard drive, and
display.
•
•
•
If the Pre-boot System Assessment completes successfully, you receive the message
Booting Dell Diagnostic Utility Partition. Press any key to
continue
Press any key to start the Dell Diagnostics from the Diagnostics utility partition on
6
your hard drive.
After the Dell Diagnostics loads and the Main Menu screen appears, click the button
7
for the option you want.
24
System Infor mation Guide
During the assessment, answer any questions that appear.
If a failure is detected, the computer stops and displays an error message. To stop
the assessment and reboot to the operating system, press
the next test, press
If failures are detected during the Pre-boot System Assessment, write down the
error code(s) and contact Dell (see "Getting Help" in your User's Guide for the
appropriate contact information) before continuing on to the Dell Diagnostics.
.
Option Function
Express Test Performs a quick test of devices. The test typically takes 10 to
20 minutes and requires no interaction on your part. Run
Express Test first to increase the possibility of tracing the
problem quickly.
Extended Test Performs a thorough check of devices. This test typically takes
1 hour or more and requires you to answer questions
periodically.
® ®
Windows logo appears, continue to wait
; to retest the component that failed, press
immediately.
.
; to continue to
.