S&P REC.AIRSENS R Mode D'emploi page 9

ENGLISH
EN
REC.AIRSENS RF is an intelligent radio frequency receiver that can be paired
with up to 4 AIRSENS RF devices regardless of whether these are CO2, VOC or
RH versions. This solution provides indoor air quality (IAQ) control by creating
demand control ventilation systems for single-zone and multi-zone installations.
SECURITY
Installation must be carried out by a qualifi ed professional. Make sure that the
installation complies with mechanical and electrical national regulations. Once
in service, the appliance must comply with corresponding Directives.
Do not use this device in explosive or corrosive atmospheres.
This appliance can be used by children aged
from 8 years and above and persons with re-
duced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
must not play with the appliance. Cleaning and
user maintenance shall not be made by chil-
dren without supervision.
INSTALLATION
This device must be installed in a dry environment (IP20), over a fl at surface
through fi xing points (see Fig. 3) and will require a type X installation. To open
the frontal cover, fi rst loosen the captive screw with a screwdriver. Then press
and rotate upwards on the edges of the cover (see Fig. 4). For safety reasons, the
power supply cable must be retained using the support provided (see Fig. 5a &
9