Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
A Open HARDWARE FOR STEP 1.
1
B Remove 4 PRE-INSTALLED SCREWS (5) and
TOP CAP COVER (6)from MAIN FRAME (4).
C
Carefully pull the CABLE (1) through the
CONSOLE MAST (2) using the LEAD WIRE
(3) located inside the CONSOLE MAST (2).
D Attach CONSOLE MAST (2) to MAIN
FRAME (4) using 4 BOLTS (A) and 4 FLAT
WASHERS (B). Tighten to 40 Nm / 29 lb-ft.
E
Attach the TOP CAP COVER (6) to the MAIN
FRAME (4) using 4 PRE-INSTALLED SCREWS (5).
F
Attach the CONSOLE MAST BOOT (7) to the
TOP CAP COVER (6) by snapping it into place.
7
2
1
2
Hardware For Step 1
Description
Qty
A
Bolt
4
B
Flat Washer
4
Note: Be careful not to pinch
any wires while attaching the
upper assembly.
3
1
A
B
5
6
4
5
A Open HARDWARE FOR STEP 2.
B Slide HANDLEBAR (8) onto
the CONSOLE MAST (2).
C
Attach using 1 FLAT WASHER
(E), 1 HANDLEBAR CAP (9), 1
FLAT WASHER (F), 1 SPRING
WASHER (G) and 1 BOLT (H).
Tighten to 40 Nm / 29 lb-ft.
D Repeat on other side.
2
Hardware For Step 3
Description
Qty
E
Flat Washer (25 mm)
2
F
Flat Washer (19 mm)
2
G
Spring Washer
2
H
Bolt
2
8
E
F
H
9
G
E50
5
Publicité
Table des Matières
