Table des Matières
Publicité
Applications
This hot-air tool is intended for all of the hot-air applications listed here, subject to compliance with safety regulations and the utilization of original Leister accessories:
• Welding of all thermoplastic synthetic materials
• Welding of foils & plastic sheeting
• Shrinkage & forming of thermoplastic synthetic materials
Deutsch
English
Warning
Français
DANGER! Danger when opening up the tool, as live components and
Español
connections are exposed. Therefore, before opening it, unplug the tool to
Português
ensure disconnection from the mains. Before putting into operation, check
Italiano
power supply cord and connector as well as extension cable for electrical
Nederland
and mechanical damage.
Dansk
Incorrect use of the hot air tool (eg overheating of the material) can
Svenska
present a fi re and explosion hazard, especially near combus t ible
Norsk
materials and explosive gases.
Suomi
Do not touch the heating element housing, air nozzle and discharging
plastizised material when they are hot as they can cause burns. Let
Eλληνικά
the tool cool down. Do not point the hot air fl ow and the discharg ing
Türkçe
plastizised material in the direction of people or animals.
Polski
Magyar
Caution
Česky
The voltage rating stated on the tool must correspond to the mains
Slovensky
voltage.
Românã
For personal protection on building sites we strongly recommend
Slovensko
the tool be connected to a RCCB (Residual Current Circuit Breaker).
Български
The tool must be operated under supervision. Heat can ignite
Eesti
fl ammable materials which are not in view.The machine may only be
Lietuviu
used by qualifi ed specialists or under their supervision. Children
Latviešu
are not authorized to use this machine.
Русский
日本語
Protect tool from damp and wet.
中文
Repairs should only be carried out by authorized Leister service
points. Restricted to use with original Leister accessories and
ﻋﺮﺑﻲ
replacement parts.
ภาษาไทย
24
Translation of the Original User Manual
• Activation/detaching of solvent-free adhesives & hot melt adhesives
• Thawing of frozen water pipes
• Drying of watery-moist surfaces
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distri-
butor/seller shall apply. In case of guarantee or warranty claims any manu-
facturing or workmanship defects will either be repaired or replaced by the
distributor at its discretion. Warranty or guarantee rights have to be verifi ed by
an invoice or a delivery document. Heating elements shall be excluded from
warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandato-
ry provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and
tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered
or changed by the purchaser.
Conformity
Leister Technologies AG, Galileo-Strasse 10, 6056 Kaegiswil/Switzerland,
confi rms that this product, in the version as brought into circulation through
us, fulfi ls the requirements of the following EC directives.
Directives:
Harmonized:
Standards
Kaegiswil, 17.10.2017
Bruno von Wyl, CTO
• Soldering of copper pipes, solder connectors
& metal foils
2006/42, 2014/30, 2014/35, 2011/65
EN 12100, EN 55014-1, EN 55014-2, EN 61000-6-2,
EN 61000-3-2, EN 61000-3-3, EN 62233,
EN 60335-1, EN 60335-2-45, EN 50581
Christoph Baumgartner, GM
Publicité
Table des Matières
