Metabo HPT WH 18DBDL2 Instructions De Sécurité Et Mode D'emploi page 16

English
(1) Removing the hook.
Remove the screws fi xing the hook with Philips screw
driver. (Fig. 11)
(2) Replacing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fi x the hook fi rmly.
(Fig. 12)
7. About Remaining Battery Indicator
When pressing the remaining battery indicator switch,
the red indicator lamp lights and the battery remaining
power can be checked. (Fig. 13)
When releasing your fi nger from the remaining
battery indicator switch, the indicator lamp changes
indication of LED light mode. The Table 6 shows the
state of red indicator lamp and the battery remaining
power.
Switch panel
ON
ON
OFF
Remaining Remaining
battery battery
indicator indicator
lamp switch
16
Groove
Screw
Hook
Fig. 11
Groove
Screw
Hook
Fig. 12
Fig. 13
State of lamp Battery Remaining Power
The battery remaining power is
enough.
The battery remaining power is a half.
The battery remaining power is nearly
empty.
Re-charge the battery soonest
possible.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
8. Remaining battery indicator
You can check the battery's remaining capacity by
pressing the remaining battery indicator switch to light
the indicator lamp. (Fig. 14, Table 7)
The indicator will shut off approximately 3 seconds
after the remaining battery indicator switch is pressed.
It is best to use the remaining battery indicator as
a guide since there are slight diff erences such as
ambient temperature and the condition of the battery.
Also, the remaining battery indicator may vary from
those equipped to a tool or charger.
State of lamp
Lights ;
The battery remaining power is
over 75%
Lights ;
The battery remaining power is
50%–75%.
Lights ;
The battery remaining power is
25%–50%.
Lights ;
The battery remaining power is
less than 25%
Blinks ;
The battery remaining power
is nearly empty. Recharge the
battery soonest possible
Blinks ;
Output suspended due to high
temperature. Remove the
battery from the tool and allow it
to fully cool down.
Table 6
Table 7
Battery Remaining Power