Assembly And Operation - Metabo HPT WH 18DBDL2 Instructions De Sécurité Et Mode D'emploi

APPLICATIONS
○ Driving and removing of machine screws, wood
screws, tapping screws, etc.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Fig. 5).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 5).
Latch
Battery
Pull out
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.

ASSEMBLY AND OPERATION

Handle
Push
Insert
Fig. 5
1. <UC18YSL3>
Connect the charger's power cord to a receptacle.
When the power cord is connected, the charge
indicator lamp will blink in red. (At 1-second intervals)
<UC18YFSL>
Connect the charger's power cord to a receptacle.
When the power cord is connected, the pilot lamp will
blink in red. (At 1-second intervals)
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Firmly Insert the battery into the battery charger as
shown in Fig. 6.
Battery
Charge
indicator lamp
Guide rail
<UC18YSL3>
3. Charging
<UC18YSL3>
When inserting a battery in the charger, the charge
indicator lamp will blink in blue.
When the battery becomes fully recharged, the
charge indicator lamp will light up in green. (See
Table 2-a)
● Charge indicator lamp indication
The indications of the charge indicator lamp will be as
shown in Table 2-a, according to the condition of the
battery charger or the battery.
English
Pilot lamp
Charger
<UC18YFSL>
Fig. 6
Battery
11