Grinding Wheels; Accessories - DeWalt D28114 Guide D'utilisation

4-1/2" (114.3 mm) and 5" (127 mm)

Grinding Wheels

Type 27 guard
Quick-Change
backing flange
Type 27 depressed
center wheel
threaded clamp nut

Accessories

It is important to choose the correct guards, backing pads and flanges
to use with grinder accessories. See pages 10–12 for information on
choosing the correct accessories.
Type 27 guard
Type 27 hubbed wheel
6" (152 mm) Grinding Wheels
Type 27 guard
stamped steel
Quick-Change
backing flange
Type 27 depressed
center wheel
threaded clamp nut
WARNING: Accessories must be rated for at least the speed
recom mended on the tool warning label. Wheels and other
accessories running over rated accessory speed may burst and
cause injury. Threaded accessories must have a 5/8"-11 hub. Every
unthreaded accessory must have a 7/8" (22.2 mm) arbor hole. If it
does not, it may have been designed for a circular saw and should
not be used. Use only the accessories shown on pages 10–12 of this
manual. Accessory ratings must be above listed minimum wheel
speed as shown on tool nameplate.
10
Type 27 guard
Type 27 hubbed wheel