Publicité
Les langues disponibles
Les langues disponibles
STEP 5: Pre-drill holes in Plastic Jamb (B2) using
1/8" drill bit and screw to walls with # 6 - 1" PH
screws (B15).
STEP 7: Center the Sill (B10) with Tracking Guides
(B9L, B9C, B9R) at the shower threshold between
the Plastic Jamb adaptors ( B2). (If required, you can
trim sill accordingly).
STEP 9: Make sure the Wall Jamb (B1) rests on the
small lip of the Sill (B10) as shown on the picture.
STEP 6: Insert Door Tracking Guide Left (B9L),
Center (B9C) and Right (B9R) at each end and the
center of Sill (B10) respectively. Do Not screw into
place yet.
STEP 8: Insert the Aluminum Wall Jamb (B1) from
the bottom to top over the Plastic Jamb (B2) and Sill
(B10).
STEP 10: Starting from the bottom, align the pre-
drilled holes in the Aluminum Jamb (B1) to line up with
the Adjustment Blocks (B11).
6
Publicité
