GENUINE F935P3 Instructions Importantes page 25

Measure the visible part of the basket shaft to verify it is
fully seated.
Model
*C20
*C30-*C40
*C60
49. Remove tools used for drawing the Basket Assembly through
the new Bearing Housing Assembly.
50. Re-install the basket pulley, key and belt in the reverse order
of removal. Apply Loctite 260 (Green) to the basket pulley
screw prior to re-installation and torque to 31.9 ± .3.2 lb-ft.
Refer to Figure 47 .
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
CHM2117K_SVG
Figure 46
Basket Shaft Measurement
1.75 in. [44 mm]
1.84 in. [46 mm]
1.85 in. [47 mm]
1. Key
2. Basket Pulley
3. Belt
4. Basket Pulley Screw
51. Align the pulley and check the belt tension. Refer to Opera-
tion/Maintenance manual for belt tension and alignment spec-
ifications.
52. Re-install the shell front, door and door bezel assembly.
53. Install the F8513501 Shell Front Gasket Kit in the location
marked in Step 10.
54. Check the basket front to shell front centering alignment at
the 3 o'clock, 6 o'clock, 9 o'clock and 12 o'clock positions.
Basket centering should be evenly spaced and should not vary
by more than .125 (1/8) inch [3 mm]. Refer to Figure 48 .
25
CHM3290P_SVG1
Figure 47
Form No. 5-10-92ENR6