Publicité
Les langues disponibles
Les langues disponibles
4
1. F8376801 Bearing Plate [*C18-*C20]; F8376802 Bearing
Plate [*C27-*C30]; F8376803 Bearing Plate [*C40];
F8376804 Bearing Plate [*C50-*C60]
2. F8377001 Cross Bar
3. F8385701 Screw
4. Basket Shaft
46. Fit the assembled Puller Yoke (refer to the Tool Preparation
Work section) over the Cross Bar installed onto the basket
shaft in Step 45.b. Refer to Figure 22 .
1. Assembled F8376601 Puller Yoke
2. F8377001 Cross Bar
3. F8376801 Bearing Plate; F8376802 Bearing Plate;
F8376803 Bearing Plate; F8376804 Bearing Plate
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
1
3
CHM2056K
Figure 21
Figure 22
47. Fit the Basket Puller Tool over the Puller Yoke assembly by
attaching the arm support around the Cross Bar, ensuring the
large threaded rod is seated in the center of the one (1) of two
(2) F8376701 Bearing Bushings installed in the Puller Yoke.
Refer to Figure 23 .
2
1. Large Threaded Rod (from F460129 Basket Puller Tool)
2. Assembled F8376601 Puller Yoke
3. F8377001 Cross Bar
4. Bearing Puller Arm Support (from F460129 Basket Puller
Tool)
5. Bearing Puller Cross Bar (from F460129 Basket Puller
Tool)
48. Using a 27 mm Wrench, turn the large threaded rod into the
one (1) of two (2) F8376701 Bearing Bushings. This motion
will draw the Basket Assembly into the shell.
49. Measure the amount the basket shaft is protruding from the
end of the trunnion assembly to verify the shoulder of the
shaft is fully seated against the inner race of the rear bearing.
Refer to Figure 24 for the measurement per capacity.
15
Figure 23
Form No. 5-10-92ENR6
Publicité
