Cooper Lighting Solutions MT125 Directives page 3

MT125 825-0050.qxp:Layout 1
Note: Estimated assembly/installation time is 15 minutes.
CAUTION: Always turn off power at fuse box or circuit breaker before
removing or installing any light fixture.
Step 1: This mounting plate has been designed to work with a variety of
different junction boxes. Line up the holes in the mounting plate with
the screw bosses in your junction box.
Note: If holes in mounting plate do not match the screw bosses in your junction
box, drill holes in the mounting plate using an 1/8˝ drill bit to match screw
bosses in junction box.
Step 2: Take the gasket (C) included with this mounting plate and position it
behind the mounting plate. Line up the screws in the mounting plate
with the appropriate hole pattern in the gasket and remove gasket
material in those holes.
Step 3: Connect lampholder wires to supply wires from house (white to white
and black to black) using wire nuts (E). Attach the ground wire from
your house to the copper colored wire (coming from the fixture cover
plate) using a wire nut.
WARNING: Fixture should be installed by a qualified electrician or by persons
with experience in household wiring. The electrical system, and the method
of electrically connecting this fixture to it, must be in accordance with the
National Electrical Code and local building codes.
Step 4: Attach the mounting plate to your junction box using the screws
provided (F), making sure that the gasket is properly aligned and that
all screws are tightly secured. To prevent moisture from entering the
junction box, apply a bead of silicone sealant around the edge of the
mounting plate where it attaches to the junction box and any
open holes.
WARNING: Do not touch fixture during use as the fixture housing gets
extremely hot. Turn off fixture and allow to cool before replacing bulb.
Step 5: Insert gasket (D) into lampholder and screw bulb (A) into lampholder
(do not overtighten bulb).
Step 6: Turn power on at main fuse/breaker box.
Aiming the light
Loosen the knob on the side of the light housing. Tilt fixture head up or down to
desired position then retighten knob.
WARNING: Deviation from the assembly instructions may result in a risk of
fire or electric shock.
SAVE THESE INSTRUCTIONS.
Two-year limited warranty
Cooper Lighting Solutions ("the Company") warrants this product ("the
product") against defects in material or workmanship for a period of two years
from date of original purchase, and agrees to repair or, at the Company's
option, replace a defective product without charge for either replacement parts
or labor during such time. This does not include labor to remove or install
fixtures.
Call for customer service and/or missing or damaged parts (800-334-6871)
1/25/08 9:22 AM Page 3
3