Stanley SLP 2050 Instructions De Montage, D'entretien Et D'utilisation page 13

OPERATING INSTRUCTIONS
2
Removing Power Washer Unit from Frame for
Handheld Operation
• Locate latches on the lower side of frame. Unlock
latches by pulling downward on the latches. Place a
foot on the pad at the front of the lower frame and
then lift the power washer unit off the frame.
Operation Tips
• If you hear the motor run intermittently when the
trigger is not being squeezed, that is normal.
The pump is priming itself so it is ready to operate
when the trigger is squeezed. Turn off the power
washer if not being used after five minutes.
• The o-rings on the bayonet end of the nozzle should
be cleaned regularly and lubricated with non-water
soluble grease such as petroleum jelly (not included).
• Keep the nozzle cleaning wire for use in unclogging
the nozzle. If you lose the cleaning wire, a
straightened paper clip also works.
93919_16ANR024_Stanley 2-in1_ENG-FR-SP_11_17.indd 13
3
How to Avoid Damaging Surfaces
• Damage to surfaces being cleaned occurs because
the impact force of the water pressure exceeds
the durability of the surface. Bare wood can be
penetrated, paint can be peeled off, etc. You can vary
the force of your power washer by controlling:
1. The angle of the surface being cleaned
2. The distance of the nozzle from the surface being
cleaned
• Never use a narrow high pressure stream of water on
soft surfaces susceptible to damage.
• Use the 25˚ angle quick connect nozzle when
cleaning windows. Be sure to place the nozzle
approximately 4 to 5 ft. away from the window with
the nozzle at 45° angle. Squeeze the trigger and vary
the spray pattern and angle until optimum cleaning
efficiency is achieved.
Using Power Cord
• Remove the power cord from the unit by swiveling
the cord hook to the right or left. The power cord
then can be slid off to either side of the power
washer unit.
• Swivel cord hook back to center when ready to wrap
the cord back into place for storage.
13
16/12/23 下午1:06