Operating Instructions - Stanley SLP 2050 Instructions De Montage, D'entretien Et D'utilisation

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS
• Turn on water supply at the faucet to completely open.
• Make sure the power switch is off (light will be off).
• Unwind the power cord completely and plug
into a grounded 120 volt outlet.
• Turn the safety lock button on the spray gun to
unlocked. While pointing the spray gun in a safe
direction, squeeze the trigger on the spray gun until
there is a steady stream of water, letting the water and
air out of the hose.
93919_16ANR024_Stanley 2-in1_ENG-FR-SP_11_17.indd 11
• Push the power button to turn the unit on (red
power light will turn on). The unit will turn on for 1
- 2 seconds and shut off. This is a normal function of
the auto start feature.
• Squeeze the spray gun trigger to begin pressure
washing.
• Begin power washing by squeezing the trigger on the
spray gun all the way into the handle.
• Release the spray gun trigger to stop the power
washer.
• Allow the motor to come to a complete stop before
squeezing the trigger again.
• Squeezing rapidly will cause the auto start feature to
miss an on/off cycle that may prevent it from turning
on while squeezing trigger after rapid squeezing. Use
slow, deliberate trigger pulls to avoid this.
OFF
Lock
K
ON
11
16/12/23 下午1:06