Emissions Information - Powerplay HOTROD HR233HB27ARNLQC Instructions De Montage, D'entretien Et D'utilisation

Safety Information
• NEVER spray any electrical outlet with your power
washer.
Note: High pressure spray may damage fragile items
including glass.
• Improper treatment of a power washer can damage it
and shorten its life.
• DO NOT point spray gun at glass when using red (0°)
MAX nozzle.
• NEVER aim spray gun at people, animals, electrical
devices or plants.
• If you have questions about intended use, ask dealer or
contact qualified service center.
• NEVER operate units with broken or missing parts, or
without protective housing or covers.
• DO NOT by-pass any safety device on this machine.
• DO NOT operate power washer above rated pressure.
• DO NOT modify power washer in any way.
• Before starting power washer in cold weather, check
all parts of the equipment to be sure ice has not formed
there.

Emissions Information

The U.S. Environmental Protection Agency (and
California Air Resource Board for equipment certified
to CA standards) requires that this engine comply with
exhaust and evaporative emission standards. Locate the
emissions compliance decal on the engine to determine
what standards the engine meets, and to determine which
emissions warranty applies. The engine is certified to
meet the applicable emission standards on gasoline. It is
important to follow the maintenance specifications in the
Maintenance section to ensure that the engine complies
with the applicable emission standards for the duration
of the product's life. This engine utilizes lean carburetion
settings and other systems to reduce emissions.
Tampering with or altering the emission control system may
increase emissions and may be a violation of Federal or
California Law.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
• NEVER move machine by pulling on hoses. Use handle
provided on unit.
• Check fuel system for leaks or signs of deterioration,
such as chafed or spongy hose, loose or missing clamps,
or damaged tank or cap. Correct all defects before
operating power washer.
• This equipment is designed to be used with Power Play
authorized parts ONLY. If equipment is used with parts
that DO NOT comply with minimum specifications, user
assumes all risks and liabilities.
• NEVER allow high pressure hose to come in contact with
hot exhaust or exhaust gases. Hot surfaces will damage
Hose permanently.
Acts that constitute tampering include but are not limited to:
• Removal or alteration of any part of the intake, fuel, or
exhaust systems.
• Altering or defeating the governor linkage or speed-
adjusting mechanism. to cause the engine to operate
outside its design parameters
If you are aware of any of the following symptoms, have
your engine inspected and repaired by your servicing
dealer:
• Hard starting or stalling after starting
• Rough idle
• Misfiring or backfiring under load
• Afterburning (backfiring)
• Black exhaust smoke or high fuel consumption
6