ASROCK B560M-HDV/M.2 Manuel Utilisateur page 21

Chassis Intrusion and
Speaker Header
(7-pin SPK_CI1)
(see p.1, No. 16)
Serial ATA3 Connectors
Right Angle:
(SATA3_0:
see p.1, No. 8)(Upper)
(SATA3_1:
see p.1, No. 7)(Lower)
Vertical:
(SATA3_2:
see p.1, No. 11)
(SATA3_3:
see p.1, No. 10)
USB 2.0 Header
(9-pin USB_5_6)
(see p.1, No. 14)
USB 3.2 Gen1 Header
(19-pin USB3_3_4)
(see p.1, No. 6)
20
SPEAKER
DUMMY
DUMMY
+5V
1
SIGNAL
GND
DUMMY
SATA3_2 SATA3_3
USB_PWR
P-
P+
GND
DUMMY
1
GND
P+
P-
USB_PWR
Vbus Vbus
Vbus IntA_PB_SSRX-
IntA_PA_SSRX- IntA_PB_SSRX+
IntA_PA_SSRX+ GND
GND IntA_PB_SSTX-
IntA_PA_SSTX- IntA_PB_SSTX+
IntA_PA_SSTX+
GND
GND IntA_PB_D-
IntA_PA_D- IntA_PB_D+
IntA_PA_D+ Dummy
1
Please connect the
chassis intrusion and the
chassis speaker to this
header.
These four SATA3
connectors support SATA
data cables for internal
storage devices with up to
6.0 Gb/s data transfer rate.
* If M2_1 is occupied by a SATA-
type M.2 device, SATA3_0 will
be disabled.
There is a USB 2.0 header
on this motherboard.
This USB 2.0 header can
support two ports.
There is one header on
this motherboard. This
USB 3.2 Gen1 header can
support two ports.