CLAS OH 5303 Mode D'emploi page 8

OH 5303
SPECIFICATIONS
Lifting capacity : 3T
Max. height : 460mm
Min. height : 135mm
Net weight : 34,5Kg
Package size : 725x370x210mm
• Read, study and understand all warnings and operating instructions prior to use.
• Do not overload this jack beyond the rated capacity.
• This jack is designed for use only on hard level surfaces capable of sutaining the load. Use on other than hard
level surfaces can result in jack instabiity and possible loss of load.
• This is a lifting device only. Immediately after lifting, support the vahicle with jack stands.
• Do not go under or allows anyone under the vehicle until it hasbeen supported with jack stands.
• Do not move or dolly the vehicle while on the jack.
• Lift only on areas of the vehicle as specifi ed by the vahicle manufacturer.
• Center load on saddle prior to lifting.
• No alterations shall be made to the jack.
• Failure to heed these warnings may result in personal injury and/or property damage.
1. Insert Upper Handle (36) into Lower Handle (35) and fasten with Hex Cap Bolt (34).
2. Loosen Bolt (28).
3. Insert handle assembly into Handle Socket (22). Make sure handle assembly engages Gear Shaft (32) by
turning handle back and forth and observing movement of Release Valve Gear (31).
4. Tighten Handle Bolt(28) to secure handle assembly.
Note: Refer to parts list for index numbers found in parenthesis.
GARAGE FLOOR JACK 3T
WARNING
ASSEMBLY