Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OH 5303
Sometimes during shipment and handling, air gets into the hydraulic system, causing poor lifting performance.
Before initial operation, purge any air from the system by fully opening pump release valve(turn handle counter-
clockwise). Then, while holding the saddle down, pump handle rapidly several times.
Raising the jack
• Turn handle clockwise until resistance is felt to close release valve. Do not over tighten.
• Place jack directly under object to be lifted. Make sure saddle accepts weight firmly and centrally. Check
positioning under slight load to confirm jack or load will not slip, or move suddenly.
• Raise jack by pumping handle until desired height is reached. After lifting, secure and transfer load to jack
stands or other appropriate means. Do not use jack as the only means of support.
Lowering the jack
• Slowly turn handle counter-clockwise. Speed of descent is controlled by amount release valve is turned.
Always store jack in the fully lowered position, and the handle in the upright position.
N° Description
1
Front Caster
2
Washer
3
Retainer
4
Rear Wheel Ass'y
5
Bearing Bottom
6
Steel Ball
7
Bearing Cap
8
Washer
9
Nut
10 Arm Shaft
11 Retainer
12 Washer
13 Screw
GARAGE FLOOR JACK 3T
USE
PARTS LIST
Qty
N° Description
2
14 Nut
2
15 Rear Shaft
2
16 Nut
2
17 Bolt
2
18 Washer
38
19 Torsion Spring
2
20 Pin
2
21 Washer
2
22 Handle Socket
1
23 Pedal Spring
4
24 Pin
4
25 Handle Socket
2
26 Pedal
Qty
2
2
4
1
2
1
1
4
1
1
1
1
1
Publicité
Table des Matières
