Publicité
Les langues disponibles
Les langues disponibles
3. Align the back panel of the new accessory with the
flanges on the range side panels right and left rear
corners. Make sure the backguard's front face is
outside the flange on the front side of the range.
4. Reinstall screws removed in Steps 1 and 2.
Toe Kick Panel
Tools Needed
T-20 Torx head screwdriver or drill
Protective work gloves
Remove the Front Foot Cover Assemblies
1. Remove the (2) T-20 Torx head screws securing the
foot cover assembly to the range base, as shown in the
figure below. Repeat for the other front foot cover
assembly.
2. Remove the leg covers by sliding the top, outer sleeve
of the leg covers off the extruded dimples of the base.
Installing the Toe Kick Panel
3. Remove protective plastic covering from the Toe Kick
Panel.
4. Beneath the range, with the holes and flange facing up,
wrap the Toe Kick Panel around the base.
5. The mating part has extruded dimples on both sides for
which the holes of the Toe Kick Panel should seize.
You should feel a definitive snap, letting you know that
the part has been installed.
6. Mount the Toe Kick Panel on both sides of the unit into
the extruded dimples using the (4) T-20 Torx drill point
screws provided.
English | 2 |
Publicité
