Tripp-Lite WEBCARDLX Mode D'emploi page 6

Installation
3 - Static IP Address Assignment/Terminal Menu
Configuration Settings
3-1
Determine IP Information: The WEBCARDLX / WEBCARDLXE / WEBCARDLXMINI
can support a single static IPv4 address (requires setting the IP address, subnet
mask and gateway) and/or a single static IPv6 address. In addition, the
WEBCARDLX / WEBCARDLXE / WEBCARDLXMINI can support a single static IPv4
or an IPv6 DNS address that is required to be entered.
3-2
Configure Terminal Emulation Program: If you have not already done so,
download the serial over USB driver (TL-cdc) from the Tripp Lite website. The driver
can be found by going to tripplite.com/support and typing WEBCARDLX in the
search field. To install the driver, follow the instructions provided. Once the driver is
installed and a COM port has been assigned, set your terminal emulation program
to use the COM port that corresponds to the USB port.
3-3
Connect WEBCARDLX / WEBCARDLXE / WEBCARDLXMINI to Computer:
Connect your PC to the Micro-USB port on the WEBCARDLX / WEBCARDLXE /
WEBCARDLXMINI using the cable provided.
6