Maintenance And Care - Tetra AquaArt LED Evolution Line 100 Mode D'emploi

Masquer les pouces Voir aussi pour AquaArt LED Evolution Line 100:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
Switching on
F
The switch for switching on the lighting is located on the right-hand side of the hood.
There are two switch positions for selecting the colour of the lighting:
Day lighting: The lighting unit emits daylight white light.
Night lighting: The lighting unit emits blue light. This creates an attractive moonlight effect.
Ideally the light should be on for 8 to 12 hours per day.
We recommend using a timer for turning the light on and off.
Introducing the fish
You should allow the aquarium and filter time to stabilise before introducing any fish (see en-
closed brochure).

Maintenance and care

Please refer to the enclosed brochure for information and advice regarding aquarium care.
For information on the maintenance of additional appliances such as filters, heaters and air
pumps please refer to the appliance operating manuals.
Replacement of the lighting unit
The lighting unit can be obtained as a spare part from the Tetra Service Centre at www.tetra-
service.net.
WARNING Danger to life due to electric shock!
Risk of electric shock if the lighting unit falls into the water!
Always disconnect the power plug of the lighting unit before starting work.
Please proceed as follows:
G
1. Open the aquarium hood.
We recommend covering the aquarium with, e.g. a sturdy piece of cardboard, to prevent
any parts falling into the water.
2. Pull the power cable of the lighting unit through the opening of the rear flap.
3. Undo and remove the eight external screws of the lighting unit.
Only use a manual screwdriver - do not use a power tool.
Support the hood while removing the screws to avoid damaging the hood.
4. Repeat the process in the reverse order to fit the new lighting unit.
Hand-tighten the screws.
5. Connect the power plug.
Cleaning the lighting unit
Only use a soft cloth for cleaning in order to avoid scratches.
Only use cleaning agents that are specifically recommended for aquariums.
BA_TL50175_AquaArt_LED_Evolution5 5
EN
19.12.2014 09:14:02
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Aquaart led evolution line 130

Table des Matières