AENO TB1 Mode D'emploi page 14

to the device. To clean the blender blade
in, make sure that the bowl is securely seated on the blender base and that the
bowl lid is closed.
Preparing for operation
Wash the blender bowl
soapy water and wipe it dry before the first use and each subsequent use.
WARNING! Never allow water to get to the bottom of the blender bowl base
. Short circuit of electrical contacts will occur and the device will break down.
Place the bowl
connector must fit into the groove of the blender body
connector must fit into the blade shaft connector on the bottom of the bowl
base . The rubber compensators
base.
NOTE. If the bowl can not be installed on the blender housing, remove it from
the base and twist the motor shaft connector
hand half a turn in either direction.
Operating the device
Place food in the bowl
clockwise until the grooves on the large lid align with the protrusions on the
bowl (See figure b). After that insert the small cap
and turn it clockwise (See picture c). To open the large and small lids turn them
counterclockwise.
NOTE. The device will immediately stop working if you open the large lid. If you
need to add food or spices while the blender is running, you can open the small
lid to do so. Use the measuring cup
can find recipes
aeno.com/documents.
14
, the large lid
on the blender housing
. Then place the large lid
of various
use the brush
and the small lid
(See picture d). The bowl
must fit into the recesses of the bowl
in the blender housing
to dose spices and other products. You
dishes in the
. Before plugging
with warm
. The motor shaft
on the bowl and turn it
into the large cap
full instructions
aeno.com/documents
by
at