Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Switch the appliance on for a couple of seconds so that the oil can be
distributed evenly. Use only the provided oil for lubrication.
The clipper blades should be oiled regularly (after each use) to keep them
always lubricated.
A
d
j
u
s
t
a
b
l
e
l
e
v
A
d
j
u
s
t
a
b
l
e
l
e
v
The lever provides additional length adjustment without using a comb
attachment (very short cut). When the lever is in its uppermost position, the
blades will give the closest cut and leave the hair very short. Pushing the lever
downward gradually increases the cutting length a bit. In the lowest position the
lever will leave the hair approximately in 1mm length.
If thick hair cutting has jammed the blades, the lever can help you to remove
hair that is wedged between the two blades without removing the blades. Move
the lever back and forth a couple of times. This can help to keep the blades
clear of cut hair.
T
e
c
h
n
i
c
a
l
d
a
t
a
T
e
c
h
n
i
c
a
l
d
a
t
230 V 50 Hz, 7 W, protection class II
This appliance is GS approved and is built to according to CE norms.
D
i
s
p
o
s
a
l
D
i
s
p
o
s
a
l
Please observe the environment! Dispose the packaging according to the local
garbage regulations. Dispose paper and carton separately from plastic bags into
the corresponding containers. If at any time in the future you should need to
dispose of this product please note that waste electrical products should not be
disposed of with household waste.
The symbol (crossed dustbin) on the product, the package or in
the instructions for use isindicates this. Please recycle where
facilitie exist. Check with your local authority or retailer for
recycling advice. Dispose the appliance at the end of its
lifespan according to environmental considerations.
(Waste Electrical and Electronical Equipment Directive)
e
r
e
r
a
31
Publicité
Table des Matières
