Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USING THE COMB ATTACHMENT
To attach a comb attachment hold it with teeth up, then snap comb attachment
to the clipper blade. Ensure that the comb attachment is fixed properly. 4 comb
attachments are included in delivery (cutting length 3, 6, 9, 12 mm).
CUTTING:
When cutting the hair for the first time cut with the attached length attachment
using the "biggest" length. Ensure that the comb attachment is fixed properly.
Caution risk of injury! The blade is very sharp! Always take care when
using the appliance. Never push it fast or violent.
Switch on and start trimming the hair as desired. It is recommended to beginn at
the side of the head and then move the hair clipper slowly from the bottom
upwards. Gently put the clipper against the hair, the teeth of the comb
attachment facing upwards. Hold the appliance in a flat position to the head.
Hair cutting requires practice and it is always better to let the hair longer when
cutting them for first time.
Use the 10 or 20 mm hair length setting to cut the top hair on the head quite
short. Use the 3 or 9 mm setting for brush cut. Hold the length attachment flat
against the head, slowly start trimming from the front to the back. Caution: Its
recommended to leave the hair longer for the first few haircuts.
C
l
e
a
n
i
n
g
t
h
e
b
C
l
e
a
n
i
n
g
t
h
e
b
Use the cleaning brush to remove any hair remaining between the blades and
from the cutting head.
Then place 1 or 2 drops of the provided oil onto the blade for lubrication. Gently
replace the blade holder and ensure that it is engaged properly.
If necessary remove the blade by unscrewing the two screws at the back.
When assembling the blades the two blades must be realigned properly.
To realigne the blades, simply match the upper and bottom blades teeth up,
exactly point for point (the end of the top blade should be approximately 1-2 mm
back from the bottom blade).
l
a
d
e
s
l
a
d
e
s
30
Publicité
Table des Matières
