electric appliances! DANGER OF ELECTRICAL SHOCK!
Never try to repair the device yourself, for all repairs consult an authorised
expert. For safety reasons a broken or damaged cord may only be replaced
by an equivalent cord by the manufacturer, our customer service department
or a similar qualified person.
Keep the appliance and the cable away from humidity, heat, direct sunlight,
moisture, sharp edges.
Switch off the device whenever it is not in use, even if it is only a short moment.
Always allow the appliance to cool down before cleaning it or storing it.
Do not use the appliance if the comb attachment has been damaged or if
the blades are broken, as this might cause injury.
Do not use outdoors or operate where aerosol (spray) products are being
used or where oxygen is being administered.
If the connection cord is damaged it must be replaced by the manufacturer,
the after-sales service department or a similar qualified person in order to
avoid risks and dangers.
Should the cord be damaged, it must be replaced by a competent qualified
electrician(*) to avoid any danger. Do not operate any appliance with a
damaged cord.
Ask a (*)competent qualified electrician to check and repair it.
(*) Competent qualified electrician: after sales department of the producer or
importer or any person who is qualified, approved and competent to perform this
kind of repairs in order to avoid all danger.
Additional protection may be obtained by fitting an earth-leakage circuit-breaker
(IF=30mA) into your home installation. Please consult a qualified electrician.
O
p
e
r
a
t
i
o
n
O
p
e
r
a
t
i
o
n
Ensure the appliance is clean and in proper working condition. We recommend
to wash and dry the hair first and to cut it after having it combed through.
Position the person for hair cut in a way, that the head is at your eye level.
Before cutting comb the hair so that it falls naturally.
Hold the hair clipper in a way, that it is always under maximum control.
Start to operate by pressing the ON/OFF switch.
29