Trevi 211 Instructions D'assemblage page 9

9
10
Be sure to have a vertical upright before installing the top
seat.
Place the top seat on the upper side of the upright.
Center the top seat between the two uprights and secure
with four (4) screw "Z".
11
Put the seat cap on the inside section of the seat and inter-
lock with the upright. Secure the seat cap with one (1)
screw "Z".
12
Position the safety procedures panel on the outside of the
pool. This panel must be at the most visible place from the
yard on your pool.
13
Note: See 'Safety Information" Manual, Page 1.
As described in the manual, all components of the filtra-
tion system should be placed to prevent a child to climb
on top and get access to the pool. Filtration system must
be install at 1m (40'') from the pool wall.
Using a little bit of stone dust (or sand), place at level a
patio stone 61cm x 76 cm (24" x 30") before installing the
motor and filter.
Position the motor on the stone and insert the two nozzles
to connect the hoses.
Then, install the filter tank. Adjust the lateral assembly
properly in its channel. It is sometimes necessary to
install the laterals.
Patch the center hole of the lateral assembly using the
plug to allow filtering sand to flow into the tank.
UPRIGHT INSTALLATION
TOP SEAT INSTALLATION
SEAT CAP INSTALLATION
SCREW
''Z''
SECURITY SIGNS INSTALLATION
FILTRATION SYSTEM ASSEMBLY
Attach the uprights to the bottom joiner plates with two (2)
screws "Z", witch you will find them in the hardware bag.
Uprights must be installed outside the flanged part of the
joiner plate and in the two notch of the wall track.
Snap the cap on top of the seat cap and inter-lock it on the
bottom.
Place the three (3) safety stickers inside the pool in a way
that it's seen from any entry point of the swimmer (See
positionning drawing).
SCREW
''Z''
SCREW
''Z''