Parts List - Trevi 211 Instructions D'assemblage

Piscines rondes
Masquer les pouces Voir aussi pour 211:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

13
Remove the plug. Install the joint in the cavity and secure
the filter head by placing the back wash position on oppo-
site side of the pool.
Install necessary nozzles, then connect hoses using col-
lars.
1. The first hose runs from the top of the pump to the side
of the filter head;
2. The second one goes from the pump to the skimmer (or
to the bottom drain valve);
3. The third goes from the front of the filter head to the
water return or from the front of the chlorinator to the
water return.
A back wash hose may be placed behind the filter head.
If there is a chlorinator and/or heat pump, it must be
assembled at the filter exit.
14
Insert threaded nozzles, if applicable, in order to be able to
screw the valve in the skimmer.
Connect the drain hose to the bottom nozzle. Connect the
motor hose to the side nozzle.
The threads on all threaded nozzles must be covered with
teflon tape prior to installing in order to prevent water
leaks. Teflon is applied to the threads as follows: little or
none on the first few threads (to facilitate introduction)
and several layers towards the end threads (for better
watertightness).
15
Top seat
Upright
Reinforcement plate
Seat cap
Joinser plate
Wall track
Top stabiliser
Wall
Bolt - nut (for 52) for wall
Drain kit (if applicable)
Screw guard
Cap
Z
Screw no 14 x1 in
FILTRATION SYSTEM ASSEMBLY (next)
DRAIN VALVE ASSEMBLY (if applicable)
10
3,05 m
31' 6'' (9,60m)
29
90
Z

PARTS LIST

37' 9'' (11,51m)
47' 2'' (14,39m)
56' 7'' (17,26m)
29
29
29
90
99
117
66' (20,16m)
75' 5'' (23,01m)
84' 10'' (25,88m)
29
29
29
135
153
171
Z
Z
Z
1m
(40 '')
30
9,14 m
21
21
21
21
21
21
21
94' 3'' (28,72m)
29
1
42
21
189

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

213

Table des Matières