Sauder Lateral File 408924 Manuel D'instructions page 8

Step 4
Turn six BLACK 9/16" FLAT HEAD SCREWS (JJ) into the
å
ENDS (A and B) until the shoulders of the SCREWS rest
on the surfaces of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Now, slide the END MOLDINGS (P) onto the ENDS (A
å
and B). To do this, line up the grooves in the MOLDINGS
over the heads of the SCREWS in the ENDS. Using your
hands, apply pressure on the MOLDINGS as you guide
the MOLDINGS onto the ENDS.
NOTE: If the MOLDINGS come up off of the SCREWS,
å
remove them and slide them on again.
These edges
should be even.
Page 8
A
P
BLACK 9/16" FLAT HEAD SCREW
(6 used in this step)
408924
B
Shoulder
JJ
Apply pressure with your hands as
you guide the MOLDINGS over the
SCREWS and onto the ENDS.
These edges
should be even.
P
www.sauder.com/services