Sauder Lateral File 408924 Manuel D'instructions page 10

Step 6
Separate the EXTENSION SLIDES (R) from the
å
EXTENSION RAILS (Q) as shown in the upper diagram
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (Q) to the ENDS (A and B).
å
Use four GOLD 5/16" FLAT HEAD SCREWS (LL).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL out to fi nd the other
hole that lines up with the hole in the END. Turn a SCREW
into this hole.
Push the black lever in and pull the SLIDE from the RAIL.
Open end
Page 10
R
Hole
B
Q
Q
GOLD 5/16" FLAT HEAD SCREW
A
408924
LL
(4 used in this step)
Open end
Q
www.sauder.com/services