Check The Digital Camera; Install The Flash To The Camera - Olympus PT-EP11 Mode D'emploi

Check the digital camera

Check the digital camera before loading it in the Case.
1. Battery Confirmation
It is impossible to change the batteries when using the Case. Make sure that you have sufficient
remaining battery capacity before use.
2. Check the remaining number of pictures
Check that the image storage medium has enough room for the number of pictures you want to take.
3. Underwater mode setting
"
Refer to How to select the shooting modes
4. Remove the strap, lens cap, filter and eye-cup from the camera.
If the digital camera is loaded without removing these, the Case cannot be sealed properly and may leak.
5. Attach the zoom gear (optional) and the antireflective ring (optional).
Example of 12-40mm f2.8 PRO lens
For details, refer to the instruction manual of the zoom gear and the antireflective ring.
For details of the combination, refer to P.21.
6. Press and hold down the u button to turn off the "EVF Auto Switch".
Press the u button to switch the display between the finder and monitor.
When turned on, the eye sensor may activate and appear the finder display.

Install the flash to the camera

Install the flash supplied with the camera.
Do not pop up the light emitting part.
Refer to P.16 when using the underwater flash.
"
(P.17).
Attaching the
antireflective ring
Lens
Antireflective ring
EN
EN 10