Front Panel; Input Selector - Vision AV-1900 Manuel Du Produit

PRODUCT MANUAL AV-1900
EN

1 Front panel

1 2
1. Input 4 Auxiliary input minijack. 4. Input 2 - Mic or Line
Plugging in here will disconnect input 5. Input 3 - Mic or Bluetooth [Push: hold
4 on rear. for 3 seconds to unpair BT device]
2. Tone control 6. Input 4 - Mic or Line
3. Input 1 – Mic or Line

2 Input selector

Mic Input with Phantom power ON
3 Input 1
Balanced XLR Mic Input
Pin 1 = ground
Pin 2 = +
2
3 4 5 6 7 8
9
7. Master volume [Push: Power on/Off]
8. Power indicator
9. Bluetooth indicator -
Flashing: pairing mode / On: paired
Mic Input with Phantom power OFF
Line Level Input
2-Phono / RCA line-level input
Mic input trim
- Turn up for less sensitive mics
- Turn down for more sensitive mics
Adjust so that front dials are set to
same position for matching volume
levels for each input
4 Input 2
2-Phono / RCA line-level input
Balanced Phoenix Bare-wire
Mic Input
5 Input 3
Balanced Phoenix Bare-wire Mic Input
6 Input 4
Balanced Phoenix Bare-wire Mic Input
Mic input trim
BT Notes
• To disable set switch to left or centre positions
• AV-1900 has one BT memory slot. It will pair with the
most recently paired device without requiring PIN.
Mic input trim
Bluetooth Indicator
Flashing: pairing mode
On: paired
Mic input trim
Bluetooth Antenna
3.5 mm Minijack input
Minijack on front panel overrides
this one
• Resetting BT by holding down Input 3 dial will delete
memory slot to allow new device to connect
• Only one device can pair at the same time
3