Construire Le Cadrage - Kohler 6103 Série Guide D'installation Et D'entretien

Masquer les pouces

Table Des Matières

Table des Matières

Construct the Framing (cont.)

Studs must be positioned roughly as shown in the "Roughing-In" section to

properly fasten the attachment clips or the bath ﬂange. Other stud locations are

optional except for those which must meet the load-bearing requirements of local

building codes. Studs must also allow for the installation of plumbing ﬁttings and

any shower door. Locate the shower door studs as required by the shower door

manufacturer.

For Bath with Apron Flanges

If apron ﬂanges are in place on the apron, ensure that the outer stud is positioned

for the apron ﬂanges at 31-1/4" (79.4 cm) from the back wall. The outer edge of

the stud should align with the edge of the apron ﬂange.

If the apron ﬂanges are not going to be used or are broken, install three evenly

distributed 2x4 blocks just behind the apron location. The blocks will prevent the

apron from being damaged and may be used to secure the apron behind the

baseboard. Measure the bath for the required clearance behind the apron and for

the location of the blocks.

For Bath with Wall Surrounds

NOTE: If the wall surrounds will be installed to a masonry wall, make provisions for

plumbing connections. For the plumbing end wall, construct a separate frame wall a

minimum of 6" (15.2 cm) from the masonry wall. For the remaining walls, use 2x2

furring strips to provide stud locations.

Ensure that the outer stud is positioned with the vertical wall ﬂanges 31-1/4" (79.4

cm) from the back wall. The outer edge of the stud should align with the edge of

the wall ﬂange.

IMPORTANT! Accessories that require backing or support are not recommended for

this installation. Installing these accessories could void the warranty.

Ensure ﬁber or other soft insulation does not drop down into the water channel.

Cover or seal any loose material. Failure to do so may cause wicking of water

from the water channel into the insulation which may induce mold, leakage, or

mildew. Ensure the channels are free of debris after installation.

For Above-the-Floor Drain Baths

Ensure the drain piping can pass through the wall and that the load bearing

requirements of the wall are satisﬁed. Modify the framing or raise the subﬂoor as

required to obtain clearance.

For All Installations

Construct 2x4 stud framing for your particular installation according to the

"Roughing-In" section.

Ensure that the framing for each stud is plumb and square within 1/8" (3 mm).

Shimming will be required if tolerances are not met.

If possible, construct an access panel in the plumbing end wall to simplify future

maintenance of all plumbing connections.