Indesit CA 55 Serie Mode D'emploi page 3

DOOR REVERSAL
Warning: Before attempting to remove the doors, switch off the electrical supply and pull out the mains plug.
It is recommended that you remove any loose items/fittings from inside the appliance and place food into insulated containers
whilst carrying out this operation.
You may require assistance to carefully lay the appliance onto its back onto suitable protective materials (i.e. original
packaging).
Remove the doors
1. Lay down the appliance on its
back.
2. Unscrew, remove and retain the
bottom hinge.
3. Slightly open the bottom door
and slide downward remove and
carefully place to one side.
4. Remove centre hinge and spacer
if fitted. Slightly open the top door
and slide downwards, remove
and carefully place to one side.
5. The pin will be removed and fixed
to the opposite side.
6. Use a thin blunt instrument to
remove the top and bottom hinge
bushes and blanking plugs from
the doors, take care not to mark
the door handle. Reposition the
blanking plugs and bushes on
the opposite side.
7. Fit the blanking plugs provided into the right hand two centre hinge holes.
8. Before changing hinge place from right side to left side, screw on left side panel should be disassemblied and after
changing hinge place, screw should be assemblied on right side panel.
Replacing the doors
1. Slide the top door upwards and locate
the top hinge pin into the door bush.
Reposition the centre hinge on the
opposite side.
2. Carefully slide bottom door upward into the
centre hinge pin.
3. Unscrew the bottom hinge pin and refit it
on the opposite side.
4. Fit the bottom hinge making sure that the
door is aligned to the cabinet.
5. Carefully stand the appliance upright in
it's required location and make sure it is
sitting level on the floor. Open and close
the doors checking that the gasket makes
a good seal without any gaps when the
doors are closed.
Note: Replace loose items/fittings back into the appliance and leave for at least 15 minutes before switching back on.
GB
3