Publicité
Les langues disponibles
Les langues disponibles
Power indicator light
See details in BATTERY STATUS part
IMPORTANT:
When only one light is illuminated,
your battery is overly discharged,
even though the trimmer may still
be capable of hedge trimming.
Continuing to operate your
trimmer with the battery in this
discharged condition may reduce
the life and performance of your
battery.
When no light is illuminated,
at least one battery is not fully
installed or battery may be
defective, please double check
the batteries are fully seated into
position.
Remove the blade sheath
Starting and stopping
Rotating rear handle
NOTE :
•
Unlock the locking switch before
rotating.
•
After rotating the handle to the
desired position, adjust it a little
until a click can be heard.
12
WARNING:
•
Always make sure that the
handle is locked in the desired
position before operation.
•
Always make sure the locking
switch is locked before starting
the hedge trimmer.
Top cutting
WARNING: If any parts are
missing, damaged or broken, do
not operate your hedge trimmer until
all damaged parts have been replaced
or repaired. Failure to do so could result
in serious personal injury. DO NOT
USE WITHOUT FRONT HANDLE AND
SAFETY GUARD.
Side cutting
WARNING: Stop operating the trim-
mer before rotating the handle.
Lubricating the Cutting Blade
NOTE : It is important to use only the
recommended standard lubricating oil
(WD-40) to avoid damage to the blade.
To store your hedge trimmer
Hedge trimmer
All manuals and user guides at all-guides.com
See Fig. F
See Fig. G
See Fig.
H1, H2
See Fig.
I1, I2
See Fig. J
See Fig.
K1, K2
See Fig. L
See Fig. M
HOW TO USE YOUR HEDGE
TRIMMER
Before cutting an area, inspect it first and remove
any foreign objects that could become thrown or
entangled in the blades. Always hold the trimmer
with both hands and with the blade away from you
before turning it on.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the
blade.
Allow the cutting blades to reach full speed before
cutting. When operating, keep the cutting blades
away from people and objects such as walls, large
stones, trees, vehicles, etc.
If the blade stalls, immediately stop the trimmer.
Release the two Switch Levers before attempting to
clear jammed debris from the cutting blades.
Wear gloves when trimming thorny or prickly growth.
Do not attempt to cut stems that are too thick for the
cutting blade.
Top cutting
Use a wide sweeping motion (See Fig. E1). A slight
downward tilt of the cutting blades in the direction of
motion gives the best cutting results.
Side cutting
When trimming the sides of the hedge, begin at
the bottom and cut upwards, tapering the hedge
inward at the top. This shape will expose more of
the hedge, resulting in a more uniformed growth
BATTERY STATUS (See Fig. F )
Before starting or after use, press the button beside
the power indicator light on the machine to check
the battery capacity. The indicator lights displays
the battery condition as follows:
Battery indicator
light status
Five green lights
(
) are
illuminated.
Two, three or four
green lights are
illuminated.
Only one green
light (
) is
illuminated.
No light is
illuminated.
Battery condition
The two batteries are in a
highly charged condition.
The two batteries have a
remaining charge. The more
lights are illuminated, the
more battery capacity.
At least one battery is
depleted and needs to be
charged.
At least one battery is not
fully installed or battery
may be defective.
EN
Publicité
