Tripp-Lite UPB-10K0-2U1C Manuel De L'utilisateur page 6

USB Device Charging Instructions
Notes:
• Before charging your devices for the first time, fully charge the power bank
prior to use.
• A power button is located on the side of the power bank. When pressed
once, the LEDs will illuminate to indicate the power banks's remaining
battery capacity. When all devices are disconnected, the power bank will
stop any device charging taking place.
• When a device is connected to the USB-C port, but appears as if the charge
is being used for the power bank itself, hold the power button down for
3 seconds to switch the charge from the power bank to the device.
• When charging a USB device, the LEDs will illuminate to indicate the
battery capacity level (see table below):
LED Status
●●●●
●●●○
●●○○
●○○○
○○○○
● = LED Illuminated
○ = LED Off
1. Using the included USB Type-C cable or a USB cable suitable for
your device, connect your mobile devices to the USB A and/or
USB-C ports on the power bank.
2. The devices will begin charging, with the LEDs operating per the
above notes and table.
Power Bank Battery Capacity
100%-75%
74%-50%
49% - 25%
24% - 1%
0
6