Bimar RTY-30 Notice D'instructions page 10

 Do not pull on the cord to disconnect the plug from the socket.
 If the supply cord is damaged, it must be replaced by the
manufactuer, its service agent or similarly qualified persons in order
to avoid a hazard.
INSTALLATION
 After removing the packing materials, check the integrity of the heater; if you
are unsure, do not use it and ask for qualified professional help. The packing
materials (plastic bags, polystyrene foam, nails, etc.) must be kept out the reach
of children because they are potential sources of danger.
 Before connecting the appliance, check that the voltage values shown on the
data plate correspond to those of the electricity supply network. In the event of
incompatibility between the electric outlet and the plug of the heater, have the
outlet replaced with another more suitable type by professionally qualified
personnel, who will make sure that the section of the wires of the outlet is
appropriate for the absorbed power of the heater. In general, the use of adapters
or extension cords is not recommended; if their use is indispensable, they must
conform to existing safety standards and their current capacity (amperes) must
not be less that the maximum of the applian ce.
 The power socket must be easy to reach so the plug can be removed quickly in
case of emergency.
 To not place the appliance near sinks or other container of liquids (minimum
distance of 2 meters) to avoid the risk of it falling in.
 Keep the fan far away from fabrics (curtains, etc.) or unstable materials that
could obstruct the air intake grille; make sure that the front is free of unstable
materials (dust, etc.).
 Make sure that the electric cord is not touching rough, hot or moving surfaces
and not twisted or wrapped around the appliance.
 Do not use the appliance with a timer or a programmer or with a system that can
switch on the appliance automatically, to avoid risk of fire, since a fire risk exists
if the heater is covered or positioned incorrectly.
 Stand the appliance on a horizontal, flat surface or table; do not stand on a
inclined plane (the appliance could upset).
 In the event of a breakdown or poor operation, turn the fan heater off and ask
for professionally qualified help.
USE INSTRUCTIONS
Before each use, verify that the unit is in good condition, the electric cord is not
damaged, if the power cord is damaged, it must be replaced by the manufacturer
or a competent qualified electrician or a person with similar qualifications, in
order to avoid any risk.
10