Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2
INSTALLING BACK AND SIDE WALLS
NOTE – INSTALL ONLY ONE WALL AT A TIME AND REMOVE FILM FROM WALLS
PRIOR TO INSTALLATION.
A) Wipe all back side of panels and walls with a damp cloth to remove any dust or
debris and allow to fully dry.
B) Apply adhesive in a zig-zag pattern on the wall within marked lines, keeping bead
thickness to 1/8" (3mm) or less. See Illustration 7.
NOTE: Applying beads of adhesive thicker than 1/8" (3mm) may make it difficult
to spread behind the panel once it is up and installed creating a ripple
effect on the panel.
C) Move rear panel onto the wall keeping a space of approximately 1/8" (3mm) off of the
surface of the tub deck or shower base and keeping panel between the marked
lines previously drawn. Press panel firmly over entire surface to ensure firm
contact of panel to adhesive on wall. See Illustration 8.
NOTE: It may be necessary to brace or support the panel against the wall until
the panel stays securely in place. Place a cloth under the supports to
prevent marring of the walls surface.
D) Install side panels in the same manner using the same adhesive pattern. Wipe off
any excessive adhesive with mineral spirits.
3
INSTALLING THE CORNER PANELS
A) Place corner panel into rear corner of shower and check for proper fit of corner panel to shower walls.
NOTE: Make sure corner panel is aligned right side up so that flat shelving surface is facing upward.
Ensure corner panels completely overlap both rear and side panels by at least 1/4" (6mm).
B) Apply adhesive to one rear corner at a time (See Illustration 9) top to bottom, side to side and on back of the corner
panel (see Illustration 10) and place into rear corner of shower (See Illustration 11). Press firmly to hold in place.
NOTE: It may be necessary to brace or support the
corner panel in position until the adhesive
dries. Use cloth under any support to prevent
any marring of the walls finished surface.
C) Wipe the panel down with a damp rag while continuing
to apply pressure to the panel to ensure it makes
complete contact.
NOTE: WIPE ANY EXCESS ADHESIVE FROM
THE PANEL WITH A DAMP RAG OR
MINERAL SPIRITS.
4
APPLYING SEALANT AND INSTALLING SHOWER HANDLE AND SHOWER HEAD
A) Allow 24 hours for the wall panel adhesive to dry before applying the sealant.
B) Apply a bead of sealant around all corners, outside edges of panels, corner panels
and deck of tub or shower base. See Illustration 12.
C) Install the shower handle and shower head per the manufacturer's instructions. Be
sure to apply sealant to all trim plates.
NOTE: ALLOW 24 HOURS FOR THE SEALANT TO DRY BEFORE USE.
Install the shower door or shower curtain rod according to the manufacturer's instructions.
APPLY SEALANT
ALONG THE BACK
Illustration 9
Illustration 10
- 3 -
Illustration
7
Support
Braces
Illustration 8
CORNER PANELS
Illustration 11
Illustration 12
7 5 55 7 8 - 10 0 Rev. 4 0 2 /2 0
Publicité
Table des Matières
