Sauder Harbor View Serie Instructions D'assemblage page 17

Step 12
Carefully stand your unit upright.
å
To insert the PULL-OUT TOP (I) into your unit, line up the LOCKING EXTENSION SLIDES (Z) on
å
the TOP with the LOCKING EXTENSION RAILS (Y) on the unit and push the TOP into the unit
until the drawer is fully inserted. The drawer will push in hard until it is all the way in, then it will
slide in and out easier.
To insert the INNER UPRIGHTS (M) into your unit, line up the EXTENSION SLIDES (40MC)
å
on the INNER UPRIGHTS with the EXTENSION RAILS (40MA) on the OUTER UPRIGHTS (L)
and push the INNER UPRIGHTS into the unit until the INNER UPRIGHTS are fully inserted. The
UPRIGHTS will push in hard until they are all the way in, then they will slide in and out easier.
Center a SCREW COVER (16P) over the head of each SCREW and press fi rmly.
å
(4 used)
16P
To cover screws
I
M
M
40MC
40MA
Z
Y
Page 17