Table des Matières
Publicité
Step 7
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (F) and lay it over your unit.
Make equal margins along all four edges of the BACK (F). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the
å
FIXED SHELF (D) and SHELF UPRIGHT (N).
NOTE: A perforation has been provided for access through
å
the BACK. Carefully cut out the hole in the BACK for
cord management.
Place a LEVELER BRACKET (17E) over the holes in the bottom
å
edges of the ENDS (A and B). Use a hammer to drive a PROPEL
NUT (14M) through each BRACKET and into the holes in the
edges of the ENDS (A and B). Now, turn a LEVELER (18E) into
each PROPEL NUT.
NOTE: The LEVELERS are used to level the unit
å
when it is standing upright.
Cut out this hole for
cord management.
A
17E
18E
14M
Page 12
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(46 used in this step)
These holes must line up
over the FIXED SHELF (D)
and SHELF UPRIGHT (N).
F
B
1N
Publicité
Table des Matières
