Danfoss TP5001 Range Instructions D'utilisateur page 3

Note: If set up for 4 events per day, events 3 & 4 are skipped. If set up
GB
for 2 events per day, events 2, 3, 4 & 5 are skipped. In both cases the
events are re-numbered.
Before you start
Open the fl ap on the front of the programmer and
press the RESET button with a non-metallic object
until the display goes blank. This will ensure that
the factory programmes are set and that the micro-
RESET
computer in the product is operating correctly.
Customising the display
For the sake of clarity, the instructions assume that the display setting
uses a 24 hour clock, °C and that days of the week are numbered 1-7,
(where 1 is Monday). All of these settings can be personalised after the
thermostat has been programmed, see pages 8 and 9.
Setting the correct date and time
Your TP5001 incorporates a real time clock with calendar function that
automatically changes time in both Spring and Autumn. The time and
date is set in the factory for the CET time zone, and does not normally
require adjustment. If you live in another time zone refer to "Time zone
off set" on page 11. However, should it be found necessary to adjust
time or date for any other reason refer to the following instructions.
Setting the date
Press and hold Λ and PROG for 3 seconds, to
display date in dd/mm/yy format.
3