Technical Data; Commissioning The Device; Important - Madas RG/2MCS Manuel Technique

Masquer les pouces Voir aussi pour RG/2MCS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2.0 - TECHNICAL DATA

• Use
• Ambient temperature (TS)
• Minimum operating pressure
• Max operating pressure
• Allowable pressure PS
• Safety lock closing time
• Accuracy class
• Overpressure shut off accuracy unit
• Closing pressure class
• Relief valve
• Connecting the vent
• Mechanical strength
• Rp threaded connections
• Flanged connections that can couple with PN 16 flanges
• NPT threaded or ANSI 150 flanged connections
• In compliance with
2.1 - MODEL IDENTIFICATION (for configurations see page 45 - 50)
RG/2MCS: Pressure regulator - without safety shut-offs
RG/2MBZ: Pressure regulator - with safety shut-offs

3.0 - COMMISSIONING THE DEVICE

3.1 - OPERATIONS PRIOR TO INSTALLATION
• It is necessary to close the gas upstream of the device prior to installation;
• Make sure that the line pressure DOES NOT EXCEED the maximum pressure declared on the product label;
• Protective caps (if any) must be removed prior to installation;
• The pipes and inside of the device must be clear of any foreign bodies;

• IMPORTANT:

• to avoid possible pumping and/or disturbances in the gas flow, a straight pipe section equal to at least 5 DN must be
installed (downstream of the regulator);
• install manual gas closing devices (e.g. ball valves) upstream and downstream of the regulator to protect it from any
pipe leak test;
• do consider that if the regulator is equipped with a relief valve, the latter is suitable for small quantities of gas to be
discharged and CANNOT replace the relief valve installed separately as a specific device;
Madas Technical Manual - 5|5.2a - REV. 0 of 5
: non-aggressive gases of the three families (dry gases)
: -20 ÷ +60°C
: 0.5 bar
: 5 bar
: 5 bar
: < 1 s
: AC=10 - (Pa ± 10%)
: AG=10
: SG=30
: tested according to the indications in EN 334
: G 3/8
: Group 2 (according to EN 13611)
: (DN 32 - DN 40 - DN 50) according to EN 10226
: (DN 32 FL - DN 40 FL - DN 50 FL) ISO 7005 / EN 1092-1
: on request
: PED Directive 2014/68/EU - ATEX Directive 2014/34/EU
13
Apr 2019
th
RG/2MCS - RG/2MBZ

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rg/2mbz

Table des Matières