Sauder 416868 Instructions De Montage page 12

Step 8
1
D12
H
Groove
Insert the DRAWER SIDES (D12 and D13) at an angle
å
into the slot at each end of the DRAWER FRONT (H).
Start each screw a few turns before
3
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D158
D12
D964
Fasten the DRAWER BACK (D158) to the DRAWER
å
SIDES (D12 and D13). Use four BLACK 1-9/16" FLAT
HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D964) inserts into
å
the groove of the DRAWER BACK (D158).
Page 12
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D13
30S
(4 used in this step)
D13
VIEW THE T-LOCK BOX VIDEO
2
U n
s u
r f a
D12
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D964) into the grooves in the
å
DRAWER SIDES (D12 and D13) and DRAWER FRONT (H).
4
These edges
should be even.
60S
BLACK 1" PAN HEAD SCREW
(2 used in this step)
Fasten the DRAWER FRONT MOLDING (I) to the
å
DRAWER FRONT (H). Use two BLACK 1" PAN
HEAD SCREWS (60S).
416868
With the palm of your
hand, tap the DRAWER
BOTTOM down into
the groove.
fi n
i s h
e d
c e
D964
D13
H
H
I
www.sauder.com/services