Publicité
Step 7
NOTE: If your unit is not located against a wall, you have
å
the option of attaching the back with the fi nished surface
facing out.
Carefully turn your unit over onto its front edges and lay
å
the BACK (E) over your unit.
Make equal margins along the top and side edges of the
å
BACK (E). Push on opposite corners of your unit if needed
to make it "square".
NOTE: The edge of the BACK will slightly overhang the
å
edge of the BOTTOM.
Fasten the BACK (E) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the BOTTOM (D).
NOTE: A perforation has been provided for access through
å
the BACK. Carefully cut out the hole if needed.
NOTE: The bottom edge
of the BACK will overhang
the bottom of the unit.
www.sauder.com/services
These holes must line up
over the BOTTOM (D).
D
416868
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(20 used in this step)
E
1N
Page 11
Publicité
