Cequent Towing Products 75153 Instructions D'installation

Fascia
Hitch Shown In Proper Position
Equipment Required: Phillip's head screwdriver
Fastener Kit: F75153
Wrenches: 14mm, 17mm
Drill Bits: None
Rubber plugs to
be removed
(Both sides)
1 1 1 1
Qty. (6) Bolt M10 X 1.25 X 40
1. Remove shrouds both sides on Lexus RX400h.
(4) Phillip's head screws & (2) Plastic push rivets on driver's side.
(2) Phillip's head screws, (1) Plastic push rivet & 10mm bolt, passenger's side.
2. Remove tie downs and fasteners from frame rails.
3. Remove rubber plugs (2) located in each rail.
4. Raise hitch into position and install fasteners as shown above.
5. Return tie downs, fasteners, rubber plugs & shrouds to vehicle owner.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2003, 2005, 2006 Cequent Towing Products
Installation Instructions
Lexus RX330, Lexus RX400h,
Toyota Highlander & Highlander Hybrid
Exhaust
Frame rail
Existing weldnuts
6 places
2
1
Tighten all M10 CL8.8 fasteners with torque wrench to 38 Lb.-Ft. (52 N*M)
Lexus RX 350,
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV1 , SUV2
Remove tie downs
both sides
2 2 2 2
Qty. (6) Conical Washer
Sheet 1 of 3
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
N/A
3500 (1589 Kg)
Note: Fasteners typical both sides
N75153 6-21-06
Form: F205 Rev A 5-6-05
75153
70778
33075
Max Tongue
WT (LB)
N/A
350 (159 Kg)
Rev. E