Tool Lubrication; Carbon Brushes - Bosch JS470E Consignes De Fonctionnement/Sécurité

BM 2610008439 03-14_JS470E / EB 3/10/14 10:13 AM Page 13
- When cutting wheels or discs, cut from the
outside the intended radius.
7. Hook clamp(s) onto footplate, and position the
guide to that adjusted radius measurement.
8. Place lock knob(s) on proper side of clamp(s)
and securely tighten lock knob(s) on the
clamp(s) (Fig. 11).
9. Insert jig saw plug into power source, hold the
saw firmly, squeeze trigger and slowly push the
saw forward.
CIRCLE-CUTTING TIPS:
• Place small wedges in the cut as shown in Fig.
14, to keep the inner circle from spreading when
near the end of the cut.
• Use a thick jig saw blade, such as the Bosch
T101TP or T144DP whenever possible.
Preventive maintenance
W RNING
performed by unauthorized
personnel may result in misplacing of
internal wires and components which
could cause
recommend that all tool service be performed
by a Bosch Factory Service Center or Autho-
rized Bosch Service Station.

TOOL LUBRICATION

Your Bosch tool has been properly lubricated
and is ready to use. It is recommended that
tools with gears be regreased with a special
gear lubricant at every brush change.

CARBON BRUSHES

The brushes and commutator in your tool
have been engineered for many hours of
dependable service. To maintain peak
efficiency of the motor, we recommend every
two to six months the brushes be examined.
Only genuine Bosch replacement brushes
specially designed for your tool should be
used.
Maintenance
Service
serious hazard.
• Make sure that the jig saw orbital setting is at 0
(zero)
• Cut slowly so the blade will stay straight in the
cut.
Bearings which become noisy (due to heavy
load or very abrasive material cutting) should
be replaced at once to avoid overheating or
motor failure.
We
W RNING
the power supply before cleaning or
performing any maintenance. The tool may
be cleaned most effectively with compressed
dry air. Always wear safety goggles when
cleaning tools with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through openings.
C UTION
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
-13-
FIG. 14
BEARINGS
Cleaning
To avoid accidents always
disconnect the tool from
Certain cleaning agents
and solvents damage